ClairiTech Innovations Inc.

This video will help get you started.

Some situations, mostly crawlspaces, may run into an issue with the height of the crawlspace. A crawlspace unit is 30” tall and if the height of the crawl s...

Unit must be installed at floor level – approximately 3” off the floor.   Replenishment air must flow from upstairs into the basement or crawlspa...

The installation must be done in the basement or the lowest, dampest, coldest level of your dwelling. Try to find an outside wall to accommodate a 6¼” exit ...

Having proper insulated walls greatly improves your basement's ability to be at, or above dew point temperatures and avoid condensation and mold form...

Unit comes in two sections that allow for flexibility in positioning the duct at the most convenient height. You can duct from the back of the unit, or from...

Attach the flex to the vent with the provided screws. From the outside, push the flex through the 6 ¼” hole. Make sure the vent is not twisted by inse...

Unplug unit from power source before any work is started Step 1: Remove top cap be removing 4 screws. Straighten the 90° elbow by turning t...

Measure the required Unit height. Remember that the units cannot be higher than 3” to 6” off the ground. This is crucial for the DVS-CS/CH and DVS-HW models...